TV One 1T-FC-766 Instruction Manual download pdf (Page 9)

If the SDI monitor does not display a signal properly, you will need to “clone” the

EDID characteristics of an HDMI monitor, one that matches the resolution

characteristics of the SDI monitor you intend to use, into the 1T-FC-766.

To clone the HDMI monitor’s EDID information into the 1T-FC-766, perform the

following steps:

1) Set the three position switch to "User EDID"

2) Connect the HDMI monitor you wish to clone to the HDMI Input.

3) Press and hold the "Update" button until the "Video Lock" light turns on.

(The "update" light will be on during the update)

4) Reconnect the HDMI source to the HDMI Input.

Generally speaking, a user will only need to create a new User EDID default in

special cases where there is a need to force the source to provide specific

refresh rates and/or resolutions (720p60 only, 1080i59.94 only, etc.).

Very few users should ever need to touch the User EDID option.

5.2 Default HDMI Input Switch Conditions and LED Indications

The default signal condition for the three position HDMI EDID switch is as

follows:

•

USER EDID - Native Mode720p@60

• HD EDID - Native Mode 1080i@60

• 3G EDID - Native Mode 1080p@60

The meaning of the various LEDs is as follows:

• EDID Update LED: This LED will illuminate when the EDID information is

being updated.

• Video Lock LED: This LED will illuminate when the input HDMI has received

a signal and locked to it.

• HDMI/DVI LED: This LED will illuminate when the input source is an HDMI

• signal and will not illuminate when the input is a DVI signal.

• 3G LED: This LED illuminate when the input HDMI signal is 1080p@50/60.

• HD LED: This LED illuminate when the input HDMI signal is

1080p@24/25/30, 1080i@50/60 or 720p@50/60.

• SD LED: This LED illuminate when the input HDMI signal is 480i/576i.

• The power LED will illuminate any time power is applied to the unit.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

TV One 1T-FC-766 Instruction Manual Page 9